How it works: Exhaust in your laser machineHP Persson
This is a hot topic on many Facebook groups and forums, where people quickly suggests links and details of what they bought and how good it works.
But very few of these people actually know why it works good, and if it will work good for the reader.
To start off this article – you do not need a big fan to have a good exhaust.
What a big fan does is complementing the problems with the machine and exhaust setup, but you get a hefty electricity bill and loud noise every time you use the machine.
How does it work?
Air always want to equalize in pressure, if you have a window open inside your house you can feel the draft from the air equalizing when opening a door.
This effect is something we take advantage of in our laser machines and keeping the need for a big fan far away.
Chinese sellers want to keep the cost down and price up, they are not engineers and just add the parts that “almost” works. The original exhaust is utterly crap and should be one of the first products you buy.
How to optimize your exhaust system
Think of the laser machine as a box, you want a wave of air going trough it with the smallest interference possible.
To make this possible you need to add fans to your machine as a intake. It does not matter if you use the front of the machine, or use the bottom/floor as intake.
This method is helping your exhaust setup in two ways.
1: Your exhaust fan does not need to put the case in (as much) negative pressure
2: The extra flow will also help with fumes and smoke inside the machine
Seal your machine
Sealing your case is also a good fix. This will lower the escaping smoke from the machine and reduce the smell to almost zero.
You can do this by adding aluminium tape, silicone sealant or hot glue in each corner and opening on the machine. Add some window rubber seal for the lid to have it air tight when closed.
Moving the exhaust fan
As explained earlier, the exhaust fan in the original configuration has to do a lot of work.
Work it should not have to do.
The fan has to…
1: Put the case in negative pressure and suck air in to the case.
2: It has to suck the smoke past the impeller
3: It has to push the smoke trough the hose out the window.
This is the big reason why some users buy big fans as they were to start a hot air balloon business, the fan has to do a lot of work.
The exhaust should not do this, and almost all fans on the market sucks good, but are very bad on creating a static pressure (pushing air in front of the impeller).
By moving the exhaust fan to the end of the hose, or at least as close you can get will help tremendously with the efficiency of your fan.
To recap the exhaust optimization
– Move the fan closer to the outlet
Reduces the load on the fan, as it doesn´t have to create a static pressure to push out the smoke out.
– Seal the machine from leakage
Helps the exhaust to work efficient, no air leaks. Less power needed to suck out the smoke.
– Add intake fans
Relieves the exhaust from taking air in, increases the sucking efficiency.
Simple computer fans works good. Depending on your machine design the size may vary. Some models have pre-made holes for 50mm fans.
Do you have suggestions on mods or optimizations you have done? leave a comment below!